HF receive antenna covering 2 to 30MHz, the receiving wire element is made of kevlar so will not break and will last a lifetime, the termination box is IP rated and has a standard SO239 female connector fitted. Simply screw the provided insulator into your facia board and hang the box from it, then string the green kevlar wire down the garden (approx 20 mtrs). Superb performance, fully potted rf circuit and wire strain relief fitted and static discharge cct.
Read the Feedback......................
Greetings,
I have finally got around to doing a proper side by side test on the antenna I
purchased from you earlier this year. I used my Kenwood R5000 connected
through a Diamond CX310 switch to the the G Whip RX, an AOR - 7000, and a simple
six metre vertical length of wire. The 20 frequencies used ranged
from MW broadcast up to 17.895 MHz. While the AOR7000 performed a
bit better than the vertical wire the G Whip was invariably at least 2 S points
higher and on a few occasions as much as 3 or 4 S points greater than either of
them. The only area where they all performed equally was around 13.900 to
14.300. I am very happy with my purchase..............Best
wishes..................Frank Holden..................VK3JFH